Have you looked at the floatit 2.0?
No, but that might be a good middle ground. I’m using a brewbuilt x3 and could attach that to a racking arm
Trying to find a good mesh size to transfer from fermenter via 1.5 inch tc port to corny keg ball lock. I don’t want it too big to clog the ball lock ports, but I’m ok with a little bit of hop matter getting through to the keg.
What size have you found best to transfer into corny kegs?
Have you looked at the floatit 2.0?
No, but that might be a good middle ground. I’m using a brewbuilt x3 and could attach that to a racking arm
For a reference point, the Classic Bouncer filter has these specs:
Connectivity: 3/8″ hose barbs
Screen: Red - 915 micron / 20 mesh
Filter Area: 4,974 square mm / 7.71 square inches
The Bouncer MD has the same red screen and Filter Area: 11,161 square mm / 17.3 square inches but also has replacement filters of two further mesh sizes:
The red one would likely fit the needs of what you describe. I have a generic equivalent that I have used inline between a carboy and keg pinlock liquid post.